Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

simulation of tapered coupler in HFSS or CST

Status
Not open for further replies.
S

sm_ali_sadreghaeni

Newbie level 5
Joined
Jan 3, 2010
Messages
10
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,341
Hi
I have a broad band tapered coupler
I simulate it in ADS momentum but when want to simulate Full wave by HFSS and CST the result are very different from ADS result?
why??
 

Hi,
I use CST to simulate of tapered slot antenna (vivaldi) and when I measure the antenna (that I create by using CST), it find that the results from CST and measurement are the same. So, I no have idea about ADS.

:smile:
 

I am having same problem with results difference when comparing genesys momentumGX results with CST MWS results.
I suppose this is because of meshing types used in momentum and CST (hexahedral mesh type) are different. In my case, I simulate coupled microstrip filter in a hairpin topology, with 75 degrees angles, so edges of lines are not parallel with CST generated mesh, this should give accuracy loss in CST.
However, I was attempting to make finer mesh into CST, and still have about 4dB S[1,1], S[2,2] difference between CST and genesys...

Would appritiate any help about why does this difference appears.
 

How to generate tappered profile in HFSS or CST?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top