---
+ Post New Thread
Page 2 of 4 FirstFirst 1234 LastLast
Results 21 to 40 of 63
  1. #21
    Newbie level 2
    Points: 1,094, Level: 7

    Join Date
    Mar 2009
    Location
    Bangladesh
    Posts
    2
    Helped
    2 / 2
    Points
    1,094
    Level
    7

    Re: PIC16F72 Code and schematic for sine wave inverter.

    Quote Originally Posted by sahu View Post
    (push switch) mens push to on OR push to on\off ???
    Yes soft touch?


    1 members found this post helpful.

  2. #22
    Member level 3
    Points: 1,218, Level: 7

    Join Date
    Feb 2009
    Posts
    56
    Helped
    4 / 4
    Points
    1,218
    Level
    7

    Re: PIC16F72 Code and schematic for sine wave inverter.

    Is the signal active low (does the mosfet switch on when the signal is low)



  3. #23
    Newbie level 2
    Points: 147, Level: 1

    Join Date
    Mar 2012
    Posts
    2
    Helped
    0 / 0
    Points
    147
    Level
    1

    Re: PIC16F72 Code and schematic for sine wave inverter.

    site is good
    Iam looking for circuit diagram of sinewave inverter



  4. #24
    Advanced Member level 5
    Points: 27,934, Level: 40
    pranam77's Avatar
    Join Date
    Apr 2008
    Location
    Mangalore (INDIA)
    Posts
    2,749
    Helped
    601 / 601
    Points
    27,934
    Level
    40

    Re: PIC16F72 Code and schematic for sine wave inverter.

    A complete technology of PIC16F72 based inveter design with all the required files is available on the same thread post #99 by "MRahman". pic16f72 sinewave inverter with asm codes. not working.
    Cheers



  5. #25
    Junior Member level 1
    Points: 851, Level: 6

    Join Date
    Aug 2010
    Location
    kathmandu
    Posts
    18
    Helped
    1 / 1
    Points
    851
    Level
    6

    Re: PIC16F72 Code and schematic for sine wave inverter.

    Is ur fusebit setting correct



  6. #26
    Newbie level 2
    Points: 714, Level: 5

    Join Date
    Feb 2011
    Posts
    2
    Helped
    1 / 1
    Points
    714
    Level
    5

    Re: PIC16F72 Code and schematic for sine wave inverter.

    Quote Originally Posted by Tahmid View Post
    I have this file, however, I haven't tested the entire thing.
    I have constructed the circuit and it worked very perfectly.
    I only used the controller circuit, i buffered the 2volts signal from the PIC with TLP250 and fed it into IR2110 accordingly.
    I have been using it for 5kva and above up to 20kva, 192vdc. The code is superb and has never disappointed.


    - - - Updated - - -

    U do not need to stress urself about conversion, just open the asm file with pic programmer software already installed on ur PC, u will see all the hex code.U will need to build JDM programmer for yourself or buy one .


    1 members found this post helpful.

  7. #27
    Full Member level 3
    Points: 1,303, Level: 8

    Join Date
    Jun 2011
    Location
    Dhaka
    Posts
    156
    Helped
    23 / 23
    Points
    1,303
    Level
    8

    Re: PIC16F72 Code and schematic for sine wave inverter.

    @segunbabs
    so at last something works!!
    "just open the asm file with pic programmer software already installed on ur PC, u will see all the hex code"
    can you please explain in detail how we get the hex code from asm file?
    regards
    Last edited by Tipu606; 1st September 2012 at 16:25.



    •   Alt1st September 2012, 14:39

      advertising

        
       

  8. #28
    Banned
    Points: 4,222, Level: 15

    Join Date
    Nov 2009
    Location
    Nigeria
    Posts
    503
    Helped
    153 / 153
    Points
    4,222
    Level
    15

    Re: PIC16F72 Code and schematic for sine wave inverter.

    I think the asm file has to be compile first using compiler before you get your hex file...


    1 members found this post helpful.

  9. #29
    Banned
    Points: 684, Level: 5

    Join Date
    Dec 2010
    Posts
    60
    Helped
    3 / 3
    Points
    684
    Level
    5

    Re: PIC16F72 Code and schematic for sine wave inverter.

    when i simulate the code with Proteus it works i see the pwm signals but when i build the circute it does.nt work,can someone tell why it does'nt work?



  10. #30
    Full Member level 6
    Points: 3,511, Level: 13

    Join Date
    Sep 2006
    Location
    MUMBAI INDIA
    Posts
    325
    Helped
    82 / 82
    Points
    3,511
    Level
    13

    Re: PIC16F72 Code and schematic for sine wave inverter.

    what problem u face in the circuit i also made it it works



  11. #31
    Banned
    Points: 684, Level: 5

    Join Date
    Dec 2010
    Posts
    60
    Helped
    3 / 3
    Points
    684
    Level
    5

    Re: PIC16F72 Code and schematic for sine wave inverter.

    That s good one, which of the code did you used?



  12. #32
    Banned
    Points: 684, Level: 5

    Join Date
    Dec 2010
    Posts
    60
    Helped
    3 / 3
    Points
    684
    Level
    5

    Re: PIC16F72 Code and schematic for sine wave inverter.

    Hello everyone, today i rebuid my circute and it seems to work but in charging mode,when i power the circute my alarm beeps pin 23 (RB3) comes one then pin 24(RB4) blinks 6times then buzzer stops,then delay for some seconds and pin27(RB6) start to blink continuously ,,,pin 11 and12 start to oscillate. but i did not connect pin5 of the pic , what is the minimum voltage needed at pin 5 ?



  13. #33
    Member level 5
    Points: 1,992, Level: 10

    Join Date
    Nov 2005
    Location
    Nigeria
    Posts
    80
    Helped
    6 / 6
    Points
    1,992
    Level
    10

    Re: PIC16F72 Code and schematic for sine wave inverter.

    Hello Segun, you said that you buffer the 2v with tlp250,remember that is the high drive what of the low drive?



  14. #34
    Full Member level 5
    Points: 6,043, Level: 18
    pnjbtr's Avatar
    Join Date
    Feb 2008
    Posts
    254
    Helped
    77 / 77
    Points
    6,043
    Level
    18

    Re: PIC16F72 Code and schematic for sine wave inverter.

    you said that you buffer the 2v with tlp250,remember that is the high drive what of the low drive?
    We need almost double volts for high side mosfet,if we compare with lower side in H-BRIDGE circuit.
    If we drive lower side with 5 volts,then we need 10 volts for upper(high) side.
    For exact voltage we can see data sheet of FET and observe vgs(voltage gate_source).
    For high side, we need boost trap circuit with(cap and diode).
    Either we are driving high side with fet drivers ic like IR2110,or with bipolar transistor.

    .


    1 members found this post helpful.

  15. #35
    Member level 3
    Points: 1,101, Level: 7

    Join Date
    May 2010
    Location
    Nigeria
    Posts
    64
    Helped
    5 / 5
    Points
    1,101
    Level
    7

    Re: PIC16F72 Code and schematic for sine wave inverter.

    hi all. pls what is the transformer voltages to wind? does this inverter charge the batteries at a constant current? what is the charging current? thanks to all.



    •   Alt11th October 2012, 18:10

      advertising

        
       

  16. #36
    Banned
    Points: 684, Level: 5

    Join Date
    Dec 2010
    Posts
    60
    Helped
    3 / 3
    Points
    684
    Level
    5

    Re: PIC16F72 Code and schematic for sine wave inverter.

    yes ,the inverter works now ,but remember that this inverter doesn't work without the feed back loop, my special thanks to segunbabs and also to M Rahman who share his work to this forum for everyone to learn and know the beauty of electronics.



    •   Alt11th October 2012, 23:02

      advertising

        
       

  17. #37
    Newbie level 5
    Points: 102, Level: 1

    Join Date
    Oct 2012
    Posts
    9
    Helped
    1 / 1
    Points
    102
    Level
    1

    Re: PIC16F72 Code and schematic for sine wave inverter.

    Quote Originally Posted by Tipu606 View Post
    the file that Tahmid posted has only the .asm file
    how to convert it to hex code file?
    **********Compiling .asm to .hex using MPLAB IDE for PIC Microcontroller*************

    see the link http://www.youtube.com/watch?v=D9ghkyLe7pI


    1 members found this post helpful.

  18. #38
    Full Member level 3
    Points: 1,303, Level: 8

    Join Date
    Jun 2011
    Location
    Dhaka
    Posts
    156
    Helped
    23 / 23
    Points
    1,303
    Level
    8

    Re: PIC16F72 Code and schematic for sine wave inverter.

    Hi RushikeshPatil
    thanks very much indeed for the youtube link !



  19. #39
    Banned
    Points: 684, Level: 5

    Join Date
    Dec 2010
    Posts
    60
    Helped
    3 / 3
    Points
    684
    Level
    5

    Re: PIC16F72 Code and schematic for sine wave inverter.

    i think there is another problem with this inverter, and the problem is charging system may be i did not get it right but the inverter seems not to be charging because when ever in connect it to mains supply mains on LED comes on , after some seconds the charging LED start blinking continuously when ever i use my amp meter to check for the charging current i see zero amps and i can here only tik tik tik sound from the transformer can someone figure out this problem for me please why it is not charging but the inverter is working fine....



  20. #40
    Newbie level 5
    Points: 102, Level: 1

    Join Date
    Oct 2012
    Posts
    9
    Helped
    1 / 1
    Points
    102
    Level
    1

    Re: PIC16F72 Code and schematic for sine wave inverter.

    does the relay give power to transformer (does relay bypass the power to transformer) you say the transformer make noise ("can here only tik tik tik sound from the transformer") it means your transformer gets the supply from relay means relay works with its signal from PIC means there is no problem in this section.
    Does you connect any other charging control ckt between relay and transformer, if then remove it.
    The problem should be in your transformer check it how much amp does he got and what is the amp of battery you are charging



+ Post New Thread
Please login
Page 2 of 4 FirstFirst 1234 LastLast