Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Binary watch on Atmega48V

Status
Not open for further replies.

Vermes

Advanced Member level 4
Joined
Aug 2, 2011
Messages
1,163
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,316
Activity points
22,318


The heart of this simple device is Atmega48V. This version is perfect for the watch, because it works with tension starting from 1,8V.
RTC PCF8563 is responsible for telling the time.
In order to display the time, a button should be pressed. It is placed in the right side of the case.
In first place hours are displayed and then minutes in second place.
Current consumption when LEDs are on is about 2mA.
When the button is off, the processor changes its mode into Power down. Current consumption is about 1uA then.
The watch is powered by CR2032 battery.



Link to original thread - Zegarek binarny na rękę
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top