Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
You can use any probe with the right impedance. Normal probes are 1MΩ but high frequency ones can be 50Ω. Normally you would buy ones with at least the same bandwidth so you wouldn't use a 100MHz probe on a 200MHz oscilloscope but a 200MHz probe on a 100MHz oscilloscope would be fine.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
