Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] PIC 16F877A based Current Source for Reverse Iontophoresis applications

Status
Not open for further replies.
nitishn5

nitishn5

Full Member level 6
Joined
Mar 27, 2011
Messages
368
Helped
92
Reputation
186
Reaction score
99
Trophy points
1,308
Location
Bangalore, India, India
Activity points
4,159
I need to make a Current Source controlled by a PIC 16F877A which should be able to

1. Set the Current Range - 0 to 500uA
2. Give up to 2 different Square Waveforms of frequency 10 mHz to 10 Hz with adjustable duty cycle with resolution 0.1%
3. Shut off when current/voltage exceeds a limit.
4. Display the current, voltage, duty cycle, frequency on a 16x2 LCD display.

Will I be able to do all this using the PIC 16F877A??
 

Yes. You can do that using pic16f877a.
If you have no experience I suggest you to use mikoc Pro. It`s free and have some good examples.
 
I need to implement at the same time a

1. 2 timers for timing the low frequency signals,
2. 2 ADC including the interrupts for sensing the current and voltage, which does not interfere with the timer when in use.
3. Software programmable reference voltages to shut off when there is any over voltages/current.
4 Also display everything on the LCD.

How do I do everything simultaneously??

---------- Post added at 23:56 ---------- Previous post was at 23:51 ----------

I cannot find mikoc pro, only the following which is not free

mikroElektronika - mikroC PRO for PIC - C compiler for Microchip PIC microcontroller development
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top