Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Defining Ports for microstrip using CST

Status
Not open for further replies.
S

srajend1

Newbie level 1
Joined
Jul 28, 2011
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,286
I am trying to simulate the S parameters of a microstrip by using ROGERS 5880 material with copper sheet below and copper strip above.When I try to use the transient analysis for solving the S parameters its giving me wrong results .I am trying to use discrete port rather than waveguide.Can someone help me out with this?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top