Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

car immobiliser principle

Status
Not open for further replies.

devil6600

Full Member level 5
Joined
Nov 15, 2008
Messages
250
Helped
7
Reputation
14
Reaction score
7
Trophy points
1,298
Activity points
2,931
hi
can any one tell me how a car immobiliser works? i know it cuts off the fuel supply, but i don't know actually how it works.
thanks
 

That´s a solenoid type, classified to wokt with chemical corrosive and explosive substances.

+++
 

thanks for all the reply

That´s a solenoid type, classified to wokt with chemical corrosive and explosive substances.

+++

can you please enlighten me on the above? i need to use immobilize in my vehicle, so i need to know exactly how does it work.
thanks for your help.
 

hi
can any one tell me how a car immobiliser works? i know it cuts off the fuel supply, but i don't know actually how it works.
thanks

Engine Immobiliser:
An engine immobiliser is an electronic device that acts toisolate the ignition system, the fuel system, the starter engine, or a combination of these three systems. As most new vehicles control these systems via the enginemanagement system, immobilisers on newer vehicles tend to interface with this component. The immobiliser will not allow thevehicle to be started withoutfirst receiving the correct signal from the person starting the vehicle. This signal can be communicated to the immobiliser unit in a number of ways:
*. Transponder: an electronic proximity device that converts electronically coded signals into radio signals. Requires no action by owner to set or unset. Usually built in to original keys.
*. Remote Key: usually a hand-held device which, when activated, transmits a radio or infrared frequency to control the immobiliser.
*. Electronic Key: a coded key, which enables the engine to start.
*. Coded Keypad: requires a code or PIN to be entered to disable the immobiliser.
*. Key Switch : a switching method to disable the immobiliser.

This video shows how the immobiliser works: B-)

YouTube - ‪How the Immobilizer Works‬‏

And this video shows how to fix an immobiliser in your car:
B-)
YouTube - ‪how to install a immobilizer on your car‬‏

And this is the DIY Tutorial for RFID Car Immobilizer:-D

RFID Car immobiliser with PIC12629
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top