Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to configure UART port-SIM5218A

Status
Not open for further replies.
T

toanfet

Newbie level 3
Joined
Jun 29, 2011
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,305
Hi all,
I have recently purchased module SIM5218A and Development KIT for sim5210 and sim5218(EVB KIT) of SIMCOM.I used USB interface to configure UART port following steps.
1.AT+CSUART=0 (3 line mode)
2.AT+IPR=9600 (Set baud rate)
3.AT+ICF=3,3 (Set control character farming,data bit=8,stop bit=1,parity=none)
4.AT+IFC=0,0 (Set local flow control .DCE,DTE:none)
But i can't connect SIM5218A with PC via RS232(COM) interface.I used Hyper Teminal +Win7
Please help me!
Thank you!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top