Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to check DRC for partial layout by Calibre?

Status
Not open for further replies.
C

chris_li

Member level 2
Joined
Nov 7, 2005
Messages
42
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,569
I am going through a tutorial, and layout just completed, which includes a few IPs without any layout!


When key in command under batch mode to check DRC,


% calibre -drc -hier -64 -runset command_file -batch


Calibre report error like "no layout of IP_name found"! Then, terminate！


How can I only check partial gds excluding those IPs?
 

you should include "EXCLUDE CELL <cell name>" into the drc rules.
 

You can also try the following settings:
LAYOUT ERROR ON INPUT NO
When YES (default) the execution stops when there is an error in the GDS (such as broken link). By setting it to NO the execution should continue.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top