Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Stepper motor driver + Atmega8

Status
Not open for further replies.
C

catalinstefanos

Newbie level 2
Joined
Nov 25, 2010
Messages
2
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Activity points
1,292
Hello. I would like to interface an Atmega8 with a stepper motor. The motor is a little bit strong and it requires about 2.2 Amps. I burnt a L298 trying to control the motor, and someone told me i should link two L298 in parallel. I made the next schematic, is it good? (the diodes are 1N5822). Thank you
 

Attachments

  • schema1.png
    schema1.png
    62.7 KB · Views: 83

You can find different schematic samples in the appNotes on the ST-site.
For instance the AN1451 or the AN1794.

To get application notes to a specific IC, you can select first the desired IC, second navigate to the section "design support".
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top