Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

PID controller with Jennic 5139..

Status
Not open for further replies.
R

royanto

Newbie level 3
Joined
May 23, 2011
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Indonesia
Activity points
1,305
Hi all.. is there anyone who understand how to program a PID in jennic 5139?
I really need this to control a DC motor over the zigbee network.. I've made several codes but so far all of them still wrong.. :(

The spesification:
I'm using an input potentiometer for the setpoint (through ADC), and get the attenuated feedback voltage from the tachogenerator (through the other ADC)..
then, the PWM output will went through the L298 driver..
 
Last edited:

try the suggestion here:
**broken link removed**

hope this help,
regards

mas erio
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top