Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

micro Ampere power supply

Status
Not open for further replies.
A

aalbaschar

Newbie level 3
Joined
Feb 1, 2006
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,301
Hi!

I'm working on designing a touch button using pico power AVR microcontroller.
upon detecting a touch, the system should activate an AC appliance. For that i will use a triac.
The whole circuit should consume no more than 1 mA at 2V.

Now I'm searching for the best way to power this circuit from the AC mains without using a bulky power supply and with lowest possible cost.

Do anyone have some suggestions?

Thanx for help
Baschar
 

Try capacitor coupling to the mains. The reactance of the cap(s) can be used to drop the voltage. You can omit C3 (on the neutral wire) in the image if you don't need isolation. Realize though, that the voltage will vary with the load And that line harmonics are coupled though the caps easily.


aalbaschar said:
Hi!

I'm working on designing a touch button using pico power AVR microcontroller.
upon detecting a touch, the system should activate an AC appliance. For that i will use a triac.
The whole circuit should consume no more than 1 mA at 2V.

Now I'm searching for the best way to power this circuit from the AC mains without using a bulky power supply and with lowest possible cost.

Do anyone have some suggestions?

Thanx for help
Baschar
Click to expand...
 

Attachments

  • LoPwr.jpg
    LoPwr.jpg
    31.7 KB · Views: 61
Thank you very much bobmcbride !
I think that is exactly what I was looking for :)
 

Word of warning, the capacitors MUST be of the correct types because if the one connected to the live mains was to fail short circuit, it would destroy a lot of components and give some one a lethal shock. :-(
Frank
 
Thanx for the warning!

I'll use ceramic capacitors with 500V Dc rated voltage.
 

You'll want a zener clamp on the output or input of the bridge to prevent huge voltages under very light load.
 
I use X or Y rated coupling caps depending on the situation.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top