Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Jitter analysis settings - Urgent

Status
Not open for further replies.

netbug

Junior Member level 2
Joined
Jan 8, 2007
Messages
20
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,457
HI,

I am about to finish my 80 MHz Quartz Crystal VCO, but I am not confident on Jitter's results. Please try to answer these questions, as fast as you can, as I have the tape-out in August of the full PLL:

1 - For the VCO circuits (autonomous circuits), which jitter measurement type should I use: FM or PM (I am using FM)? I think we should use FM for the autonomous circuits and PM for the driven ones. Is this correct ?

2 - Sweep range: should I configure it till fo, fo/2, 2fo. I have no idea on this.

3 - Integration limits: I am using 1Hz to fo/2 (40 MHz). Is this correct ? How this relates with the sweep range ?

4 - How should I plot phase noise ? Under pnoise jitter or pnoise? The results are quite different.

5 - Which is the most suitable jitter for VCO's Jc or Jcc ?

6 - I have read the Ken's papers but, if I am not mistaken, he says that the great majority of the phase noise should be close to the carrier. However, integrating from the carrier till the corner frequency, I get a lower contribution than for big offsets. Can you please comment on this ?

Thanks very much to all.

Best regards,
Pedro
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top