sendy
Newbie level 2
Hi All,
I am a newer for IBM 90nm process. In its PDK, the capacitors and resistors all have three terminals. I am just not sure how to connect the third terminal in the schematic, also in the layout.
Also, when I set up the capacitance value of the capacitor, I found we need to set up the length and width values and the software will give you the maximum and minimum capacitance value but not the exact capacitance value. How can I know if I set up the right capacitance value for the capacitor?
Could anyone tell me how to use those resistors and capacitors?
Thanks,
I am a newer for IBM 90nm process. In its PDK, the capacitors and resistors all have three terminals. I am just not sure how to connect the third terminal in the schematic, also in the layout.
Also, when I set up the capacitance value of the capacitor, I found we need to set up the length and width values and the software will give you the maximum and minimum capacitance value but not the exact capacitance value. How can I know if I set up the right capacitance value for the capacitor?
Could anyone tell me how to use those resistors and capacitors?
Thanks,