Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

changing pin and via sizes in altium

Status
Not open for further replies.

proyex

Newbie level 4
Joined
Nov 2, 2007
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,323
hi, im trying to change the size of the pins and vias of the footprints on my PCB, but i have several DIP-40 footprints, and the only way i can do this is manually changing sizes one by one, pin by pin, in properties, but i want to know if there is a way to change the size and shape of the 40 pins at same time, i need to save time, thanks
 

Vias: select a via you want to change, right-click -> find similar objects, then set "hole size" or via diameter to "same" and click OK. It will select all vias of that size/diameter and bring up the PCB Inspector. In the PCB Inspector, change the Via Diameter and Hole Size, and it will change it for all selected vias.

I think you can do the same thing with pads, but I wouldn't do it because the footprint will no longer match the library. Better to edit the footprint in the library; I normally create a PCB library for the board (Design -> Make PCB Library), then I can edit a single library instance of a footprint, and update the entire board with it.

In the PCB Library editor, you select the footprint you want to edit, then select the similar pads you want to change, either the same way as above, or you can multi-select in the Component Primitives window. in the PCB Inspector (View -> Workspace Panels -> PCB -> PCB Inspector) change the Hole Size and Top & Bottom Shape & Sizes. If you increased the hole size, review the internal layer clearances to see if they need to be changed. Then right-click on the footprint name in the Components list and "Update PCB with..."
 

    V

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top