Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] lcd interfaced with 89s52

Status
Not open for further replies.
K

kunjesh

Newbie level 2
Joined
Apr 8, 2011
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,294
My 16*2 LCD prints the data in a fashion like it increments the ASCII value by eight so when i write 1 it prints 8,fr 2 its 9,for 3 its equivalent ASCII value of 10 while interfacing with 89S52.The code runs sucessfully well in the PROTEUS.Pls suggest something..........

---------- Post added at 14:57 ---------- Previous post was at 14:55 ----------

you can reply me on parekh.kunjesh94@gmail.com
 

post your code here. let us see what mistake you have done................. are you doing any ascii conversion after receiving the data from UART???? conversion is not required.. check your code or post it here..........
 

Thanx shivaram for ur support.
I hv checked it today and got the mistke where pin no. D4 of LCD was not properly soldered so that prob. had been raised.
now it works very well.Thank you all...
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top