Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Send ATD and ATA commands from controller to GSM Modem through UART.

Status
Not open for further replies.

chennaiah173

Newbie level 1
Joined
Apr 7, 2011
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,285
How to Send ATD and ATA commands from controller to GSM Modem through UART.

Can anybody Plz send me the source code in C language
 

does it work on hyperterminal


atd+91xxxxxxxxxxx; is for dial the number

for incoming call : When the product receives a call, it sets the RingInd signal and sends the ASCII “RING” or “+CRING: <type>” string to the application (+CRING if the cellular result code +CRC is enabled). Then it waits for the application to accept the call with the ATA command.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top