Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

CST Microwave user defined excitation problem

Status
Not open for further replies.
E

enkaar01

Junior Member level 1
Joined
Apr 22, 2010
Messages
19
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Location
pakistan
Activity points
1,425
Dear Members

I defined a user defined excitaion MWS CST using VB editor , but there is some problem, sucessfull run and shows correct shape signal.plot in a new tree in CST excitation but does not show correct shape in signal list. I think there is error in code where it writes for signal but correct for plot but i could not solve plz help me
thanks
 

You can defined a user defined excitation in CST MWS. You can help me? I need a Gaussian signal excitation 1mV but in CST MWS where this signal is 1V. I do not write this code to change 1V become 1mV. You can help me? thank you very very much.

- - - Updated - - -

I am doing graduation thesis, So I need a 1mV signals excitation.Can you help me?
 

To define 1 mV excitation signal you need to define Voltage Port. Then in it's dialog box you define voltage 1mV. If you need 50 Ohm port, add lumped resistor 50 Ohm in series to your Voltage port. Next you choose excitation signal - select Gauss. Peak of your excitation signal equals the voltage you selected.
I hope that helps.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top