Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Inbalanced skew in CTS

Status
Not open for further replies.
Hi Kumar,

In all probability there will be setup and hold violations along various paths..depending on whether there are positive or negative skews at the end points...

But the thing is we may use the same skew for fixing these violations..this is referred to as useful skew...intentional placing skew to fix violations...

So as you can see we do not prioritize on reducing the skew..but rather concentrate on balancing it so that all the paths have more or less the same skew.


Useful??
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top