Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Is it possible to leach signals from a wire ?

Status
Not open for further replies.
L

Lord Loh.

Full Member level 4
Joined
Jun 19, 2004
Messages
196
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,296
Location
Texas
Activity points
1,951
Signal Leaching...

Is it possible to leach signals from a wire.

I suggest that we wind a wire around the target wire and tune the taping circuit to give a clear output of the flux that the coil is able to capture the signal...

Something similar to clamp tester...

Is this possible ? How can it be done ?
Click to expand...

This question comes from Circuit forums, I run it and did not get a satisfactory answer there. (Hope mods of this board do not mind)

I shall publish answers I get here on my forum, unless you explictly ask me not to do so. It would be good if you could give a contact method...
 

Re: Signal Leaching...

On two wire lines you can capacitive couple individually to each wire. On coaxial line there is some return current that gets through to the outside. You can put a toroid around the cable and a few turns of your own wire on the toroid. The signal pickup on both cases will be very low. All you will be able to do is detect the presence of a signal. You will not get enough to decode or otherwise use the signal.
 

Re: Signal Leaching...

Yes it's possible to eavesdrop signals from a coaxial cable, for instance.

Flexible, low-loss cables have bonded metal tape outer conductors with braided overshields. This construction provides better than 90dB shielding. Winding a suitable pickup coil (e.g. tuned) along the coaxial cable, and connecting the coil to a sensitive receiver, will do the trick.
 

Signal Leaching...

So using a sensitive receiver and amplifiers, I can evesdrop...

but can I tune in into a 10-12 wire LAN cable to leach network signals (star topology type cables) So I individually tune till I get signals from only one of the many cables and do it for each of the cabe.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top