Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how to find out fault coverage without scan (vectors only)

Status
Not open for further replies.
D

danny_isr

Newbie level 2
Joined
Jul 1, 2004
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
28
I’m looking for a way to find what is the functional coverage of our testing. We don't have scan in the current chip. So the only way to find what is the coverage is with some kind of tool that will determine what the vectors coverage is. Which tool does that, how easy it to learn it etc ?

I did use NC to find out what is the RTL coverage. But I want to find out how much the vectors that I will send to the tester are actually verifying.
What is the percentage of the fault coverage that my vectors produce?
If it's low I would write a new test to improve that.

Hope i was clear enough :)


Thanks Danny
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top