Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Assembly language instruction

Status
Not open for further replies.

eeHassan

Member level 2
Joined
Jan 28, 2011
Messages
52
Helped
0
Reputation
2
Reaction score
1
Trophy points
1,288
Location
Lahore, Pakistan
Activity points
1,615
what is the minimum size of MOV instruction in assembly language?
1 byte or 2 bytes?
 

eeHassan,
I am sure it would depend on the processor and on the particular MOV instruction. Most processors will allow you to move bytes, but some are 2 byte minimums. Which processor are you looking to use?

Sckoarn
 

hi
which controller you are asking about?
almost all processors i know have a MOV instruction in their assembly set

ml
 

4 clock cycles

---------- Post added at 22:34 ---------- Previous post was at 22:31 ----------

answer also depends addressing mode used...

---------- Post added at 22:35 ---------- Previous post was at 22:34 ----------

**broken link removed**
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top