Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

pic18f452 with labview

Status
Not open for further replies.

ali shaheen

Junior Member level 1
Joined
Aug 29, 2010
Messages
15
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
pakistan, karachi
Activity points
1,419
hello

Is there any specific way to write any command to the PIc microcontroller .....like some prefix or whatever.....as I just want to send ' 2' to the pic but it is not getting it ...because if it would then it sureluy should do the specif job defined to it...

best regards
ali shaheen
 

Dear Ali,

There is no specific way to write any command to the PIC as mentioned by you. Just write the specific tasks in com(serial or usb) port interrupt section in the PIC and go ahead. Better to use switch case statement and use characters instead of numbers if using C Code. Later you can experiment with numbers.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top