Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Design Entry Capture CIS pin swapping.

Status
Not open for further replies.
B

bart_jansen

Newbie level 4
Joined
Feb 4, 2011
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Belgium
Activity points
1,313
Hello,
I'm able to do pin swapping, but the problem is when I do it, the pin is actually moving from it current location. How to make the net name or hierarchical port/offpage connector swap instead of the pin???


Regards,
Bart.
 

how many pins you have in connector ? if have 20 pin you can make 10+10 ..you can swape those pin..
 

16 pins connector.
But it execute an autoswap so in a later stage my routing is easierto perform.
I have a module between two connectors. These modules are free to pick, they are comming from the same schematic page.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top