Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Why I can't modify the model file in OrCAD Capture

Status
Not open for further replies.
J

Jenifer_gao

Member level 1
Joined
Jun 14, 2004
Messages
38
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
552
Hi:

I was using Pspice 9 student version to learn some simulation. I input a transistor from the breakout library, and then to edit the model file. It's fine when I worked with Schematics, and I can modify the model file as I like. But when I worked with Capture, I find I can't modify the model. Every time when I checked the simulation result, I found it always use the same model file associated with MbreakN transistor. My modification doesn't work. If any experienced person can give me a hint to make the part to link to the new model file.

Thanks,
 

Hi:

I have to answer this question by myself. A ghost must be in my computer to make it failed yesterday, and work well today. I don't do anything today, I just try to do simulation again, and it works. Should I complain the tool?
 

hi
I WANT to add MAT04 transistor into the library but I dont know how to do can you tell me please

tufantamer@yahoo.com
 

right click on your MbreakN transistor, then click Edit PSpice Model
a PSpice model editor will come up, make sure u use standard Spice Syntax
Hope this helps
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top