Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Quality factor - etch angle

Status
Not open for further replies.
D

Darkcrusher

Member level 5
Joined
Dec 30, 2010
Messages
87
Helped
21
Reputation
42
Reaction score
20
Trophy points
1,288
Location
Belgium
Activity points
1,786
Hi,

I'm simulating the Quality factor for planar pcb coils. When I'm measuring the Q, it seems that it always lies in between simulation results for zero and finite thickness.

-What is the cause of this ? Does it has to do with etch angle or is it due to etching irrugaliraties or something else ?

-If it's the etch angle, which sim software can be recommended ?

Thanks in advance,

note: good answers will be rewarded with points/helpfull ;)
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top