I am a beginner in this programming stuff I had recently made a line follower robot to make which work i have to program a microchip I have taken the circuit from here :- Line Follower Robot
I even had attended a workshop at my school where those people gave me the programmer for at89c51 whose name shown on my pc is "Silicon Labs 210x USB to UART Bridge". While researching I found a software ie proload 1.4 which when I used detected the development board but not the chip it shows "Device Programmer for 89 Series 4.4 SS Chip Not Detected 0 bytes used" .In one of the pages(Atmel 89 Series Flash Programmer Ver 3.0) I saw that an adapter could make it work for 20pin chips even will it be true for my development board also..?? and would the circuit for the adapter remain same..??
And yeah I want to program AT89C2051.
Plz help me..