Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

draw size port of hfss

Status
Not open for further replies.
vcoltech

vcoltech

Member level 3
Joined
Aug 27, 2010
Messages
58
Helped
17
Reputation
34
Reaction score
16
Trophy points
1,288
Location
Vietnam UET
Activity points
1,585
Hi'. I want to draw port of hfss. it has random size.
example, port size 3χ3mm. i don't want to draw full port.
i hope every body give me some steps draw it
thanks
 

Hi
you should determine the port type: Lumped port or wave port, for lumped port its size based on the your feed input impedance, for example 50 ohm, but for wave port its width and hight are approximately 5 to 10 times of the feed line width and hight
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top