Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

ADS Momentum Layer or Substrate file generation?

Status
Not open for further replies.
T

tstoll

Junior Member level 2
Joined
Dec 22, 2009
Messages
21
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,436
Hi -

I want to model an inductor in a standard CMOS technology. Attached the cross-section of the technology for the metal layering.

Ho do I set up a layout layer in ADS which includes the overall oxid which surrounds the metal layers?

And - to perform an momentum simulation: do I have to set up a substrate or layout layer cross section?

Greetz,
Tom
 

Attachments

  • Microsoft Visio Drawing 1.jpg
    Microsoft Visio Drawing 1.jpg
    11.8 KB · Views: 142

Could that be correct?? Please comment!

Substrate:
TOP
Oxide_Passivation
Oxide_VIA3
Oxide_VIA2
Oxide_VIA1
Oxide
Substrate
/////////GND///////////

Layout Layers:
TOP
------
Oxide_Passivation
------ STRIP - pc4
Oxide_VIA3 |VIA| pcvia3
------ STRIP - pc3
Oxide_VIA2 |VIA| pcvia2
------ STRIP - pc2
Oxide_VIA1 |VIA| pcvia1
------ STRIP - pc1
Oxide
------
Substrate
/////////GND//////////
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top