Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Looking for a voltage clamp IC.

Status
Not open for further replies.
P

Pheetuz

Full Member level 3
Joined
Feb 12, 2010
Messages
162
Helped
21
Reputation
42
Reaction score
19
Trophy points
1,298
Location
Brighton
Activity points
2,835
Hi folks, I am looking for an IC that I can use to protect a data bus from the outside world so to speak.
Basically the data bus is going to be connected to a possibly unstable environment and I need to protect against voltage spikes upto roughly 40V.

The data bus is connected to a PIC and therefore needs to be able to swing upto +5V and down to 0V.

So basically what I'm looking for is a voltage clamp from 0V to 5V that will not get damaged by voltages as high as 40V.

Any ideas are very much appreiciated.

/Pheetuz
 

The easiest way is to connect a pair of diodes from the data line to +5v and earth. one anode to earth, the other cathode to +5V. This way the energy is dissipated via the diodes/5V decoupling components. I would also put in series resistors (10 -100 ohm)from the input to the diodes. The problem is that your "40v spikes" could come from a low impedance source and their energy content could see off a diode. Same argument for an IC. Needs to dissipate real power and be "fast". You have not stated any speeds or durations of the spikes.
Frank
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top