Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

how to connect atmel8052 controller to compim

Status
Not open for further replies.

genious_us

Newbie level 6
Joined
Oct 13, 2009
Messages
11
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
pakistan
Activity points
1,348
I want to cheack AT commands responce but i dont know about proteus so kindly help me that how to connect atmel8052 controller to compim or any other way to cheackk....plz send me the diagram if possible..thanks
 

I want to cheack AT commands responce but i dont know about proteus so kindly help me that how to connect atmel8052 controller to compim or any other way to cheackk....plz send me the diagram if possible..thanks
 

take a serial cable....connect the tx of one side to rx of other end of cable, and rx of one end to tx of other end... google "rs232 connection" you will get your answer
 
you can use max232 circuit that you can google for , and connect your gsm modem to hyperterminal ... if you are have a development kit it will already have a rs232 connector connect it to your computer and use hyperterminal to check the responce by sending AT comands from the PC,

if you have created the hardware for your microcontroller you can connect the rx of modem to tx of micro, and tx of module to rx of micro, and using a lcd or just an led u can check ur responces ..

if you want to use a micro and your code in proteus and connect that to your gsm engine then u can use the feature called COMPIM in proteus ..
you can search for it online ...
check this http://teeblog.blog.com/archives/381/
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top