Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to simulate a resistor in HFSS ?

Status
Not open for further replies.
X

xenopus

Newbie level 3
Joined
Jun 13, 2004
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
19
How do you simulate a resistor in HFSS ?
 

Re: HFSS question

Create a 2D object (such as reactangle) and set in Lumped RLC boundary condition. notice that you must define a Current line for it.
 

Re: HFSS question

I need a help please in this point..


From HFSS help:
Steps for Assigning Lumped RLC Boundaries
1. Select the object or object face to which you want to assign the lumped RLC boundary.

So I think I have to draw rectangle to assinge the resistor..As KMPA said

but what is the size of this rectangle?

what about if the resistor connected microstrip line to ground(microstrip//substrate//ground)

I will be greateful, anyone helps me.
Thanks.
 

Re: HFSS question

sheet size should be an electrical small compairing to simulation frequency....
anamiya bhattacharya
Project trainee
SAC,ISRO
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top