Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

help me :motor encoder

Status
Not open for further replies.

amiraa

Newbie level 5
Joined
Dec 18, 2010
Messages
9
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Activity points
1,331
hi
I need for your experience
I wil prorming by mikroc
the measur of motor by encoder then I will placed in proteus
help me
 

I need for the schema in protues or any idea for programing with mikroc
thanks
 

Well,

Due rate of pulses is commonly very high, is not a good solution achieve it at firmware.
You must use an encoder counter performed by hardware.
Depending on what uC you´re using, it may have a built-in capture module to count this.

Check this :

Rotary Encoder Circuit | Electronic Circuit Directory

+++
 

I will placed pic+motor_encoder+lcd for displaying
 

thanks for your job with me

---------- Post added at 22:57 ---------- Previous post was at 22:52 ----------

I will placed in my schema pic16f877 + motor_encoder + lcd for displaying
 

help meeeeeeeeeeeeeeeeeee
 

amiraa,

Be shure you probably will not receive a complete project.
So, the best thing to do is post here each problem you find, according it happens.

+++
 

I have a problem with dislaying speed of motor
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top