emilianop
Newbie level 1
extracting gerber file from PCB
Hi all,
This is Emiliano and I'm new in the forum.
I have a question: as far as you know, is it possible to extract a gerber file from a PCB? Is there any hardware/software able to recognize and draw the design of a PCB.
An alternative solution would be expensive, such as using X-rays or braking it.
Thank you,
Emiliano
Hi all,
This is Emiliano and I'm new in the forum.
I have a question: as far as you know, is it possible to extract a gerber file from a PCB? Is there any hardware/software able to recognize and draw the design of a PCB.
An alternative solution would be expensive, such as using X-rays or braking it.
Thank you,
Emiliano
Last edited: