2tx
Newbie level 1
I got a 1998 model Hyundai H1, with 12 pin diagnostic connector
There is only 3 pins in use.
1 K-Line Engine control diagnostic and error codes
2 K-Line Airbag diagnostic
12 GND Ground
I want to use Vagcom 409.1 to read the data
And a KKL USB Interface 409.1V cable (USB)
I want to read the air bag data
And my question is what input do I need on the interface?
I got K-line and ground, is the ground from the car signal or chassi ground?
Do I need to add +12 Volt and ground to the interface?
Any tip is welcome...;-)
Will it work?
There is only 3 pins in use.
1 K-Line Engine control diagnostic and error codes
2 K-Line Airbag diagnostic
12 GND Ground
I want to use Vagcom 409.1 to read the data
And a KKL USB Interface 409.1V cable (USB)
I want to read the air bag data
And my question is what input do I need on the interface?
I got K-line and ground, is the ground from the car signal or chassi ground?
Do I need to add +12 Volt and ground to the interface?
Any tip is welcome...;-)
Will it work?