Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Yes there is... does this answer help you?
If you don't tell us what program you are using how can anyone give a specific answer that can actually help you.
Since this is an IC tool, it's not really set up for BOM
generation. If you used a lot of generic components you
would get only "analogLib inductor" and not values, off a
schematic hierarchy tree printout.
I guess you are not up for good old fashioned manual
bookkeeping?
Thanks for Alex's advice. But it may be just as dick_freebird said, this IC design tool hasn't provided a shortcut for getting the device list, except creating a netlist as tupadupa adviced.
Thank everyone for these advice.
PS: I'm not going to be that kind of bookkeeper^_^
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.