sunil21
Advanced Member level 4
I am new to microcontroller programming.
I recently bought AT89C2051 and AT89C4051 from bangalore.
Only this 2 mc were available to buy.
the i tried to check for a programmer online and all of them are expensive and
hard to find/buy.
I read that it is possible to connect the mcs directly to paralle/serial port and
burn the code to mc.
is it possible to to with 8051/2051, if so how to do it and if not what is the
alternative.
I recently bought AT89C2051 and AT89C4051 from bangalore.
Only this 2 mc were available to buy.
the i tried to check for a programmer online and all of them are expensive and
hard to find/buy.
I read that it is possible to connect the mcs directly to paralle/serial port and
burn the code to mc.
is it possible to to with 8051/2051, if so how to do it and if not what is the
alternative.