Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

"The port has no terminals defined on it"

Status
Not open for further replies.
K

KateXX

Newbie level 4
Joined
Nov 24, 2010
Messages
7
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,315
Dear all,
I've got an error while using HFSS. I want to divide my construction and add one more port. During this process I've got "Port 'p2': The port has no terminals defined on it".
Best regards,
Kate

---------- Post added at 10:45 ---------- Previous post was at 10:44 ----------

I want to divide my construction and add one more port here File Upload - 128.
 

Dear all,
Firstly, I cannot divide it into three strips. May I use split command? Unfortunately, PIFA disappears after this...
Secondly, I have an error when I move port1 from antenna_feed to antenna_short or antenna_short2 after division...
Could anyone help?..
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top