Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

what type of DRC errors can be ignored

Status
Not open for further replies.
S

sureshnaidu

Member level 2
Joined
Sep 13, 2010
Messages
48
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,288
Location
bangalore
Activity points
1,586
I have these errrors in DRC.which can be ignored from these errors.The following are the errors iam getting

1.[1406] SkewEdge:(this error from inductor)
2.[1] 4.1J: Minimum DIFFUSION density over 500x500um^2 area is 20%.
3.[1] 4A.19P: Minimum PO1 density over 1000x1000um^2 area is 15%.
4.[3] 4A.21M: Maximum NPLUS diffusion to nearest P+ pick-up spacing is 20um
 

sureshnaidu said:
... which can be ignored from these errors.

None. In general, no DRC error may be ignored, ask your foundry. An exception is only possible if you have a signed agreement with your foundry, stating that you take full responsibility for non-functionality of the dice.

DR means Design Rules, and a rule is a rule is a rule! (Unless you know how to break them properly.) ;-)
Click to expand...
 

Erikl is correct. But errors 2 and 3 will be met after you have your filler cells put in. Either you need to put in the fillers...At the END of your design,(there is a automatic filler button in cadence if you pay for it) or the middle company between you and TSMC for example will put them in (which is what is normal). Any error with density or 20% blah blah blah will be met later on.

jgk
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top