Hyboo
Newbie level 1
Hello,
I have a project this semester in which I use ATMEGA8 and Nokia6610i. I need to capture RING from Nokia while is ringing. I use voltage converter between ATMEGA8 and Nokia for converting 5V/3V and 3V/5V. With Nokia it does not work. When I used instead of Nokia Siemens C35i, all works perfectly.
I tried connect Nokia with PC (using MAX232 and 3V/5V and 5V/3V voltage converter). I tried to send AT commands in HyperTerminal, but I did not get any response from Nokia 6610i. With Siemens C35i all works perfectly and Nokia6610i with Nokia PC Suite also works perfectly. Nokia6610i with original cable also works perfectly.
I read a lot of information about Nokia FBUS Protocol.
Must I use FBUS, or it goes easier without FBUS?
I need a special cable that I can communicate with Nokia AT commands?
How to use FBUS to send AT command ATE0????
How to receive over FBUS RING????
Thank you very much and sorry for my bad English ;-)
I have a project this semester in which I use ATMEGA8 and Nokia6610i. I need to capture RING from Nokia while is ringing. I use voltage converter between ATMEGA8 and Nokia for converting 5V/3V and 3V/5V. With Nokia it does not work. When I used instead of Nokia Siemens C35i, all works perfectly.
I tried connect Nokia with PC (using MAX232 and 3V/5V and 5V/3V voltage converter). I tried to send AT commands in HyperTerminal, but I did not get any response from Nokia 6610i. With Siemens C35i all works perfectly and Nokia6610i with Nokia PC Suite also works perfectly. Nokia6610i with original cable also works perfectly.
I read a lot of information about Nokia FBUS Protocol.
Must I use FBUS, or it goes easier without FBUS?
I need a special cable that I can communicate with Nokia AT commands?
How to use FBUS to send AT command ATE0????
How to receive over FBUS RING????
Thank you very much and sorry for my bad English ;-)