Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Need to help about the design power device

Status
Not open for further replies.
T

Tommyliu

Newbie level 5
Joined
May 28, 2004
Messages
8
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
55
Dear All

Now I must design the new power device for SDH and this element is need
to define a follow condition to imprement so I think its had somebody could help me to do it(schemtic or new idea is fine)

1.Input voltage:36~72V;regular voltage is 48V
2.Output voltage:5V; regular rate is 2%
3.Output power : 15W
4.Output circuit:below 8A
:oops:
 

Forward or flyback convertors are your solution, but I think for your application Forward converter is better selection, thids due to high level of output current.

also I think it is better to use integrated switchers available from International Reactifier : www.irf.com due to lower voltage and higher efficiency.

another solution is UC384X current mode SMPS controller.

BEST!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top