Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] Cadence 16.3 operated in Windows 7 32 bit

Status
Not open for further replies.
H

HANUMAGOUDA

Member level 1
Joined
May 17, 2010
Messages
40
Helped
3
Reputation
6
Reaction score
3
Trophy points
1,288
Location
BANGALORE
Activity points
1,550
Hi,
My self Hanumagouda Patil from India, I am facing one small problem in Cadence 16.3, i installed the same in Windows 7. Problem is after drawing the schematic once we click on the create netlist it will ask for the destination where to save, after giving all the information once i click on ok it will display a message that "saving the previous netlist " something like message will display. Can any body tell me the solution for this.... i installed this software in laptop not on desktop computer. please help me in this issue

Thanks in advance .
Regards,
Hanumagouda Patil
 

Hi HANUMAGOUDA,

Open the program with Administrator privileges.Use Run as administrator option (OR)Run the Program in Windows XP SP2 compatibility mode...
 
Hi vichu,
Thanks for your information,but i installed the software by selecting the administrator option, after that also i can not able to import the netlist to PCB Editor because of the above problem.
Thanks in advance.
Regards,
Hanumagouda Patil
 

i'm not very clear about your problems. can you please elaborate?
 

Hi Vichu,
Following is the problem, i am using cadence v16.3, i installed the same in Windows7 32 bit in my laptop. All the options are working fine, but after creating the schematic whenever i tried to create the netlist it will ask for the "netlist files directory" once i give all the information it will ask for the netlist overwrite. Once i click on OK it will not create the netlist. If i want to import the netlist from the saved directory components will not be available there. For your reference please find the attached files.
https://obrazki.elektroda.pl/97_1295319575.jpg
https://obrazki.elektroda.pl/10_1295319575.jpg
https://obrazki.elektroda.pl/28_1295319575.jpg
https://obrazki.elektroda.pl/34_1295319575.jpg
I think now u got my problem
Warm Regards,
Hanumagouda Patil
 

Hi,

I can say that the official cadence version that supports Windows 7 is 16.3.005

Regards
 

Hi HANUMAGOUDA,

I had the same problem in both 16.2 and 16.3 and ran the program with administrator privilege and fixed.If u still have the problem better re-install cadence.


Regards.
 

Hi Vichu,
Thanks for your reply, i rectified the solution by running the program as administrator.(Note: Even both time that is while installing and while opening the program you have to run as administrator)

Thanks&regards,
Hanumagouda Patil
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top