Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

serial ADC Data Transmission using uART 8051.

Status
Not open for further replies.
sidy50

sidy50

Member level 4
Joined
Dec 31, 2009
Messages
79
Helped
14
Reputation
28
Reaction score
3
Trophy points
1,288
Location
India
Activity points
1,839
Hi all,
Theres an extremely important help, i need in my project...

Here is what happens to be done...
An ADC0808 converts analog data into 8 bit Digital Data...
Now i want to transmit this Data serially through UART of 8051 & Display this data on anyone of the Ports of the other 8051uC...i have C routines for UART & ADC conversion...
But m not able to make it work properly...The Displayed Data on the Ports is Incorrect.

Pls help me, how can i make this work
Any suggestions or Similar Codes would help...

Thanx & Regards.
Sidy.
 

Did you change any configuration registers for ADC?
Regards,
Jerin.
 

No, i didnt do anything like...
I used some routines for ADC conversion...It Works
Then UART routines to transmit serially...
& Recieving UART routines at the receiver Side...

Both things when Tested Separetely Works fine...
Dunno whats wrong...
Should i post the whole code..?

Thanx.
Sidy
 

how are you taking 8 bit digital data on the UART of 8051.. i guess u'll need to take all d 8 bits first at the controller and then send it to wherever desired.

see of these help : **broken link removed**
**broken link removed**
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top