lumier
Newbie level 1
Hello,
I am using a D-Link power over ethernet to transmit power and data to LED PCBs via T568A cables. The cables are already installed and cannot be replaced. However, some of them are not working.
In T586A pinouts only green and orange pairs are responsible for data and power transmission, right? And blue and brown pairs are not in use. I was wondering if it is possible to disconnect brown and blue wires and replace them with orange and green instead. (It looks like the green and orange pinout connections are not working).
Do you know if it makes sense trying this? Other suggestions are appreciated. Thank you in advance.
I am using a D-Link power over ethernet to transmit power and data to LED PCBs via T568A cables. The cables are already installed and cannot be replaced. However, some of them are not working.
In T586A pinouts only green and orange pairs are responsible for data and power transmission, right? And blue and brown pairs are not in use. I was wondering if it is possible to disconnect brown and blue wires and replace them with orange and green instead. (It looks like the green and orange pinout connections are not working).
Do you know if it makes sense trying this? Other suggestions are appreciated. Thank you in advance.