hawk1943
Member level 3
- Joined
- Jun 14, 2010
- Messages
- 62
- Helped
- 0
- Reputation
- 0
- Reaction score
- 0
- Trophy points
- 1,286
- Location
- United Kingdom
- Activity points
- 1,859
Hi there,
I've just etched a new PCB using the attached schematic, but since populating the board the LCD no longer works, yet the code and everything else was working fine on the prototype rig...
I have the PIC 16F877 working as I have RS232 communications, but just unable to get anything to work on the actual LCD...
Does anyone have any sugguestions as to what I can try...
I have attached the source code I am using and Schematic Drawing...
The code is fully tested and worked on the prototype fine before it died on me... hence the reason I had to etch a new PCB...
I've just etched a new PCB using the attached schematic, but since populating the board the LCD no longer works, yet the code and everything else was working fine on the prototype rig...
I have the PIC 16F877 working as I have RS232 communications, but just unable to get anything to work on the actual LCD...
Does anyone have any sugguestions as to what I can try...
I have attached the source code I am using and Schematic Drawing...
The code is fully tested and worked on the prototype fine before it died on me... hence the reason I had to etch a new PCB...