Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] next step after importing dxf to board file

Status
Not open for further replies.
P

pushpamone

Junior Member level 3
Joined
Aug 18, 2010
Messages
26
Helped
6
Reputation
12
Reaction score
5
Trophy points
1,283
Location
bangalore
Activity points
1,435
Hi,
i am beginner and i want to know how to use the allegro in step wise and also i'm using PADS which been comfortable with it.
I'm able import the dxf.file to allegro so what is the next step to be followed..?

regards,
pushpa
 

Dears
What is you need to do to till you what is next step?

wait your reply
 

I have imported third party netlist to allegro but no components are placed in board,viewlog shows as netlist imported successful......even i gave padpath,psmpath also,i am not getting what wrong i have done............can place components manually but just components will be placed without net
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top