Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

ADS Layout Help needed!!

Status
Not open for further replies.
A

accountme05

Newbie level 5
Joined
Feb 17, 2009
Messages
9
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,347
hi everybody!!!

i have designed a wilkinson Power divider in ADS,
in the schemetic it is working best but when i generate layout,
i have no idea how to place shunt resistors(lumped element in case of schematic) between the microstrip lines. ..

when i calculate W and L for equalenct value for resistance, and place them between the m-lines, it changes results!!!

How can i place shunt resistor (lumped element ) in my Layout to simulate correctly.???

thanx !!!
 

You can simulate EM mircostrip lines by ADS momentum. And put your ports or terms for shunt resistor. when EM simulation was finished, you can recall this simulation data in the ADS.

Added after 1 seconds:

You can simulate EM mircostrip lines by ADS momentum. And put your ports or terms for shunt resistor. when EM simulation was finished, you can recall this simulation data in the ADS.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top