anujjamwal
Newbie level 1
i connectd my e50 with my laptop through ft232 board working at 3v3 i/o. i soldered connections as
FBUS-RX ----------> FT232-TX
FBUS-TX ----------> FT232-RX
GND ---------------> GND
i tried using AT command but no response from phone. i even tried my 6210 navigator but the same story with that too... i tested my usb-serial board by shorting tx-rx line and tried sending data and it works correct, so my usb-serial board is not faulty.
FBUS-RX ----------> FT232-TX
FBUS-TX ----------> FT232-RX
GND ---------------> GND
i tried using AT command but no response from phone. i even tried my 6210 navigator but the same story with that too... i tested my usb-serial board by shorting tx-rx line and tried sending data and it works correct, so my usb-serial board is not faulty.