Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

What SMPS topology are the best suitable for audio power amp

Status
Not open for further replies.

ynhe

Full Member level 3
Joined
May 28, 2001
Messages
184
Helped
6
Reputation
12
Reaction score
2
Trophy points
1,298
Location
China
Activity points
1,343
Hi
Please talk about what SMPS topology are the best suitable for audio power amplifier(class a ,ab, b,d or true digital amplifier).The smps power is over 250w or 300w.


ynhe
 

Re: What SMPS topology are the best suitable for audio power

two:
1.series resonant half bridge
2.and phase shift full bridge
 

Re: What SMPS topology are the best suitable for audio power

Pls see it:
 

Re: What SMPS topology are the best suitable for audio power

Hi
How about the quasi-resonant (QR) approach?

ynhe
 

Re: What SMPS topology are the best suitable for audio power

full resonant is better than quasi-resonant,and have lower EMI.
for amplifier,another factor is loop responsable speed,it is very important.
 

Re: What SMPS topology are the best suitable for audio power

8) use a topology which has the lowest peak currents.
A full bridge with active reset( UC 3875 )
one more thing your power supply should be completely shielded and should have multiple filtering at the output to get low ripple and noise.
 

Re: What SMPS topology are the best suitable for audio power

In terms of your original post, a smps topology would be class d. Class a, b, and ab are all essentially linear. I wrote an article in EDn a few years ago on class d that shows the difference from class a and b. Amazingly, it is still online: **broken link removed**
 

Re: What SMPS topology are the best suitable for audio power

Input voltage importand for selected topology.

Pushpull is best If you want to use low input voltage.

Hard switching technics produce more electromagnetic radiations
therefore you must use soft switching type design at the audio and video circuits.

If you not limited by input voltage any soft switching methode usuable.
 

Re: What SMPS topology are the best suitable for audio power

Hello

you can go to www.diyaudio.com . A complete thread is dedicated to SMPS power supplies for car audio power amplifiers.

Regards
 

Re: What SMPS topology are the best suitable for audio power

The best way is to go to national semiconductor SMPS page where you can pick out a suitable SMPS controller then read their app notes.

It's very hard to build one from scratch.

For a start, go this this page then fill in the require specs and they will tell you the part you need. At least it will give you some idea.

**broken link removed**
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top