Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how can I import sat-file-formats in IE3D?

Status
Not open for further replies.
Z

zampanampa

Junior Member level 3
Joined
Mar 12, 2002
Messages
30
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,286
Activity points
190
adix license for ie3d 9.0

how can I import sat-file-formats in IE3D?
 

gdsii ie3d

zampanampa said:
how can I import sat-file-formats in IE3D?
Click to expand...

New adix (run from program manager) coming with IE3D v10 have the ability to import SAT and export ie3d file
 

ie3d adix

ACIS (SAT)<=>3D DXF<=>GERBER<=>GDSII<=>IE3D is built in on the layout editor (MGRID) in IE3D 10.2. A user needs the ADIX license to enable the feature (except GDSII<=>IE3D).
 

In case your's IE3D is below 10.x you can use LinkCAD hxxp://www.linkcad.com/ , but this one allow import /export of planar structures only as are :
AutoCAD® DXF™, Gerber RS-274X, GDS-II™, CIF, PostScript®, IE3D . So this case the better way is to make export from SAT to any another format first and make import to IE3D after that.

IE3D10.21 time-limited trial siut you can obtain at the zeland web site after registration.
regards.
 

By the way - i had have no success when i tried to convert 3d SAT models which had been maked with Autodeck Inventor ( wire 3d coil ).
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top